Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Arlington?
Garage door work in Arlington typically runs $150 – $600 for most repairs, with a new door installation running $700 – $2,200 depending on size, material and hardware. Spring repair is usually $180 – $340 for a single spring, and a matched pair is replaced together, so a pair costs about twice that. Every job is quoted in writing first, and the written estimate is the final price.
We connect Arlington homeowners with independent local pros who are licensed and insured as their state requires, and estimates are free. Call (855) 337-1889 for a quote you can plan around.
- Typical repair: $150 – $600
- Most common call: a broken spring, quoted per spring
- New door: $700 – $2,200 installed
- Written estimate: free, and it sets the final price
Garage Door Cost Breakdown (2026)
These are typical estimated ranges for the Arlington market. Your written estimate will reflect the actual door, the hardware on it and what we find once we’re looking at the system.
| Service | Typical estimated range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
A single torsion spring sits at the low end of the spring range. A matched pair, which is what most doors actually need, lands near double that. Cables usually get replaced in pairs too, since a cable that snapped has a twin that’s been carrying the same load for the same years. Rollers and tracks are the cheapest fixes on the list and the ones most often skipped during a tune-up, which is a false economy: worn steel rollers grind the track, and a bent track loads the springs unevenly.
Opener work splits cleanly into repair and replacement. A gear, capacitor or logic board fix stays low; a full new motor with new rail and safety sensors moves toward the top of the installation range. Panel replacement depends on whether the panel is a stock profile or a discontinued one. We work on Clopay, Amarr, Wayne Dalton and Raynor doors, so a matched replacement panel is usually findable rather than a whole-door event.
What Affects Garage Door Pricing in Arlington
- Door size and material. A single-car steel door costs less to replace than a double-car wood or composite door. Material drives the install price more than labor does, since a heavier door also needs heavier springs.
- Spring type and count. Torsion springs cost more than extension springs and a pair costs about twice a single. We quote per spring so you can see exactly what’s being replaced.
- How the door is built into the house. Arlington has a lot of older housing stock, and plenty of those garages were built tight to the lot line or under the main living space. Low headroom changes the hardware setup and adds time to the job.
- Winter road salt and grit. Arlington’s winters bring plowed streets and salted roads, and that grit gets tracked into the garage and onto the tracks and rollers all season. Doors that never get cleaned run rougher and wear faster, which shortens the life of the moving parts.
- Freeze and thaw cycles. New England temperature swings work on the wood and steel panels as much as on the pavement. Panels flex, seals harden, and hardware loosens seasonally, so a door that was quiet in October can rattle by February.
- Brand and part availability. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor equipment. Knowing the system before we arrive means fewer guess-and-check hours on the clock.
One thing that doesn’t change the price much is urgency, within reason. Call us and we’ll book you in; if the door is stuck open and the house is exposed, tell us that on the phone.
How to Save on Garage Door
The cheapest garage door bill is the one you avoid by catching wear early. A dry, squealing roller or a slightly bent track costs a fraction of what it costs after a season of running on it.
- Fix the small parts before they take the big ones with them. Replacing rollers at $110 – $220 is far cheaper than the spring and cable work a grinding door eventually needs.
- Replace springs in pairs. Two springs of the same age fail within months of each other. Doing the pair in one visit costs less than two separate calls.
- Get a written estimate before anything gets touched. Estimates are free, and a written number keeps the scope honest: you know what’s included and what isn’t.
- Match the opener to the door. An oversized motor on a light door wears the hardware; an undersized one strains. A $250 – $550 opener installation sized correctly lasts longer than a cheap one that’s fighting the door.
- Ask about the whole system, not just the broken part. A snapped cable usually means the other cable and both springs are near the end of their life. One visit to service everything costs less than three emergency ones.
Worth knowing before you call: high-tension springs and cables are genuinely dangerous to handle. Torsion springs store enough energy to break a wrist or worse, and cables under load can whip. Don’t try to loosen or remove either one yourself. A trained technician handles that work with the right winding bars and the door properly secured, and that’s exactly the kind of job a pro should be doing.
If you’re weighing repair against replacement, our guide to garage door repair walks through when a fix makes sense and when it doesn’t. For a full door swap, see garage door installation in Arlington, and for spring work specifically, spring repair in Arlington covers the details. When a door fails outside the usual hours, emergency garage door service in Arlington explains how we handle it. Opener problems are covered under opener repair in Arlington, and dented or cracked sections under door panel replacement in Arlington. If you’re just up the road, garage door repair in Newton covers the same ground for that market.
Call (855) 337-1889 for a free estimate on any of it.
FAQs – Garage Door Cost
How much does garage door repair cost in Arlington?
Garage door repair in Arlington typically costs $150 – $600 for most jobs. The low end covers roller swaps and track adjustments; the high end covers cable and multi-part spring work. The written estimate sets the final price. Call (855) 337-1889 for an exact quote, free of charge.
Is it cheaper to repair or replace a garage door?
Repair is almost always cheaper short of a wrecked door: a $150 – $600 repair against $700 – $2,200 for a new installation. Replacement makes sense when the panels are structurally failing, the door is badly out of square, or you’re facing multiple repairs in the same season. Call (855) 337-1889 and we’ll give you both numbers so you can compare.
How much does a new garage door cost installed in Arlington?
A new door installed in Arlington typically runs $700 – $2,200, depending on size, material and hardware. A single-car steel door sits near the low end; a double-car door with heavier panels and new springs sits near the top. Call (855) 337-1889 for a free estimate on your specific door.
How much does spring repair cost?
Spring repair is $180 – $340 per spring, and a matched pair is usually replaced together, so a pair costs about twice that. That’s a job for a trained technician, not a homeowner: the springs store serious energy and the wrong tool can send one loose. Call (855) 337-1889 and we’ll quote it exactly.
Can you come today?
Same-day service is often available, and if the door is stuck open or the house isn’t secure, say so when you call and we’ll prioritize it. Estimates are free either way. Call (855) 337-1889 to check availability.
Why the Brand on Your Door Matters for the Bill
Diagnostic time is a real part of what you pay, and it’s the part most easily avoided. We service eight of the most widely installed residential systems: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. That covers the electronics, the door and the hardware, so the technician already knows the system in front of them instead of working it out on your time.
It also means the fix is the right one for your door. Opener electronics and door hardware have to match: a Genie motor on a door built for a different drive system will keep tripping the safety reverse no matter how many times the sensors get adjusted. Our technicians have up to 8 years of experience, and they’ve seen the common failure points across all eight brands. For the full picture of what we handle, see Newton Garage Door Repair Pros.
What a Typical Estimate Covers
Arlington is a mix of older two- and three-bedroom houses with detached or under-house garages, plus newer construction closer to the center. Older doors often carry extension springs and older openers; newer ones are more likely to have torsion systems and modern safety sensors. Which one you have changes the quote, and it’s why we ask for the brand and door type on the phone.
A typical estimate walks through the springs, cables, rollers, tracks, hinges and opener, and separates what has to be fixed now from what can wait. You get a written number before any work starts. Nothing gets added after the fact without a call to you first.
If your door is stuck mid-track or won’t close, that’s a security issue, not just an inconvenience. Call (855) 337-1889 and we’ll get you booked. If you’re outside Arlington and want to know what the local market runs there, the Newton page is a useful comparison.
Pricing reflects the Arlington market as of 2026. Newton Garage Door Repair Pros offers free estimates – call (855) 337-1889.
What Our Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Katie Thompson"Logic board on a 15 year old opener. He was upfront that a new opener would cost less than the board plus labor, and he wasn't wrong. No pressure either way."
- Robert Bennett"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Kristen Sullivan